peregrinvs
Well-Known Member
I was about to use this off the shelf stencil from Milcorem on 7.5cm Sprgr.34 when it occurred to me that I wasn’t 100% certain of where to place the markings.
I assume the 95 goes over the III on the top half of the shell, one of the Jg.11.6.43 goes on the bottom half just above the driveband and the FES markings go on the lower half on opposite sides. But where does the second Jg.11.6.43 go? Opposite the other one? I’ve spent some time googling markings, but can’t work it out. I insert the caveat that the stencil may be more impressionistic than 100% accurate.
Thanks,
Mark
I assume the 95 goes over the III on the top half of the shell, one of the Jg.11.6.43 goes on the bottom half just above the driveband and the FES markings go on the lower half on opposite sides. But where does the second Jg.11.6.43 go? Opposite the other one? I’ve spent some time googling markings, but can’t work it out. I insert the caveat that the stencil may be more impressionistic than 100% accurate.
Thanks,
Mark