satan18
Well-Known Member
Hear are a couple more of my projects which are nearing completion.
The multi coloured SD2 is one i did earlier but needed to replace a wing for a better one.
I also had a new riveting tool that needed an airing,so i made the long rivets,and had a small stock of end paddle rivets that are 40+years old and fit as per originals.
The Bare metal one is the waffsters which is undergoing re juvenation.
It was as is and painted with ronseal or some hard baked paint,and needed
a full set of rivets.
After stripping back to bare and doing the pin work this one is a minter in the metal department,with only minor re dressing required.
It has the early bannana paddles with a very nice air scoop on each side of the paddles.
Back to bare metal for mine tommorow and both will be re painted.
The multi coloured SD2 is one i did earlier but needed to replace a wing for a better one.
I also had a new riveting tool that needed an airing,so i made the long rivets,and had a small stock of end paddle rivets that are 40+years old and fit as per originals.
The Bare metal one is the waffsters which is undergoing re juvenation.
It was as is and painted with ronseal or some hard baked paint,and needed
a full set of rivets.
After stripping back to bare and doing the pin work this one is a minter in the metal department,with only minor re dressing required.
It has the early bannana paddles with a very nice air scoop on each side of the paddles.
Back to bare metal for mine tommorow and both will be re painted.
Attachments
Last edited: