Mills centre piece removal tool

[Falcon]

I made this tool at work today for removing the centre piece from Mills grenades.

Close-up: (Sorry it's a bit blurry)

Centre piece on tool:

 

[MG34NZ]

Very nice peice of work! makes my jamming 2 drill bits in the holes and levering with a screwdriver look a bit rough...LOL. I will have to fab up a similar tool
regards
MG34NZ

 

[SG500]

Good work Falcon, nicely made. I'm sure you could sell those on the forum to all those mills collectors out there.

Dave.

 

[staples57]

I second that... please let me know if you plan on selling them

Good work Falcon, nicely made. I'm sure you could sell those on the forum to all those mills collectors out there.

Dave.

 

[Falcon]

I can think of a few things I could make to sell, but the problem is finding the time to do it. I could do the Mills Tools at home if I had a lathe and pillar drill here.

The good thing about these tools is, compared to the primer removal tools, there is basically zero chance of slippage when turning.

I also made a large size bullet puller that will take a .50 BMG or similar sized round.