British Ordnance Collectors Network
Join over 14,000 collectors of inert military ordnance. Get expert identification help for shells, fuzes, grenades, and more — plus access our classifieds marketplace and decades of archived knowledge. Free to register, takes seconds.
SC1000L replica, detail needed
- Thread starter sonofhss
- Start date
Wow thy look better than the real thing, well done, cannot help with the support,,,,,,,, Dave
How it's made: fiberglass, wood, steel, wire. I start with the best, original drawings possible. I chose the SC1000L because it was huge, but short enough to fit in the bed of my 1944 Chevrolet truck.
That means it should be just over 99 inches long, the bed is about 104". The nose was made of fiberglass
on a wood and wire frame sized .200 under the print dimensions. The tail is aluminum except for the cone sections which were made of fiberglass on a special male mold. The cylinder section is a 80 gallon fiberglass water tank, very heavily modified.
That means it should be just over 99 inches long, the bed is about 104". The nose was made of fiberglass
on a wood and wire frame sized .200 under the print dimensions. The tail is aluminum except for the cone sections which were made of fiberglass on a special male mold. The cylinder section is a 80 gallon fiberglass water tank, very heavily modified.
