MK 80 series nose fuze adaptor?

[DEADLINE222]

Would anyone happen to know what the nomenclature is on the MK 80 series nose fuze adaptor?



Assuming I am not breaking a rule; may I ask where I could find a few?

 

[HAZORD]

It is the M148 Adaptor/Booster (T45E7). It is actually easier to find the bombs, fuzes, and fins than it is to find those adaptors, especially with the booster section attached.

 

[HAZORD]

Came across this last night:

http://www.ordtech-industries.com/2products/Fuzes_Bombs/Adaptor_Booster.html

If you have access to a lathe, you can make your own.

 

[ordman]

good luck I doubt you will find one

I had two rings made by Ray Mikita a couple of years ago
Sent him the material and a set of drawings along with a
tail fuze and a nose plug for thread reference They came out great
will post pic later

 

[DEADLINE222]

Thanks for the replies, guys.

I have a lathe, yet I have yet to take on threading. Someday I will have to take the plunge as I am in need of at least three units.

I was hoping that someone knew of a little-known outlet full of boxes of these things.

 

[ali059]

This is funny just thought you would also considering